Whatsminer control board repair by certified craftsmen
The control board inside the ASIC miners performs a function similar to the motherboard in a computer. Since it has the complex function of controlling and directing operation, it can sometimes be difficult to diagnose a specific point of failure.
But nothing is difficult, as long as the service center has experienced craftsmen and the necessary equipment to check. Our craftsmen will fix the Whatsminer checker - replace the chips, restore the current-carrying tracks, check the joint work of the components.What can malfunction in the Whatsminer control board?
- Network card. It is responsible for the connection to the Internet, so if your ASIC miner stopped seeing the network, the problem is most likely in it.
- RAM. Here may burn out or break from a voltage drop the chip itself , in this case, re-solder or replace it.
- The processor, also in the form of a chip, is responsible for the basic functionality. The cause of its failure may be overheating or an attempt to incorrectly overclock the ASIC miner.
- NAND memory where the ASIC miner firmware is saved. It is sensitive in heat, dust, moisture, and it breaks down because of working in unintended temperature modes and in a room without sufficient filtration and air purity.
UMC repairs not only Whatsminer, our list of services includes Bitminer, Innosilicon, Avalon and others. In some cases, it is more profitable to replace the Whatsminer control board on the ASIC miners, especially if it is in stock boo at a low price, than to re-solder and replace several burned out parts.
In such a case, the duration and cost of the repair may add up to more than the price of the replacement part. We'll be sure to provide you with a repair plan and correctly explain how you can get your ASIC miner back on line and at what cost.
We are looking forward to seeing you in our Moscow service center or have your ASIC miners delivered from any city. We can fix anything!